Calculated-industries 4095-C Pocket Reference Guide User Manual download pdf (Page 9)

Pocket RefeRence Guide — 15

Enter the Preference Mode by pressing

 (Prefs). Access each category

by pressing the  key until you reach the

desired setting. Within each category, press

the  or  keys to toggle between individual

selections. Press  to exit and set your

Preference.

Note: Press  toadvanceandpress to

backup.Pressingthe keycontinuously

inthismodewillcyclethroughallofthe

PreferenceSettings.

You may change these settings at any time

by repeating the above, and setting in a new

preference.

To reset preferences back to factory default

settings, turn your calculator off, hold down

the  key and turn the calculator back on.

For example, if you wish to display all your

dimensional area answers in square meters,

press   (Area Std), then the

 key until “AREA 0. SQ M” is displayed.

Simply exit this mode by pressing  and

all your future area answers will be displayed

in square meters.

KEYSTROKE DISPLAY

  (Prefs)

(FractionalResolution) FRAC 0-1/16 INCH

(cont'd)

(cont'd)

  Store unit cost.

  Degrees:Minutes:Seconds

(dms◄►deg) – Converts between

D:M:S and decimal degree formats;

repeated presses will toggle be-

tween the two formats.

  Paperless tape (Tape) – Accesses

the Paperless Tape mode.

 

Preference settings (Prefs) –

Used to access various customiz-

able settings.

 Backspace Function – Used to de-

lete entries one keystroke at a time

(unlike the  function, which

deletes the entire entry).

 % – Percent function.

 Used to store values in Memory

1 -  registers 1 through 9.

PREFERENCE SETTINGS

HOW TO SET PREFERENCES

The following sections detail Preference

Setting options for the PipeTrades Pro

calculator.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Comments to this Manuals

No comments