Calculated-industries 4095-C Pocket Reference Guide User Manual download pdf (Page 16)

Pocket RefeRence Guide — 29

1.EnterPipeSize:

6   STD SIZE 6 INCH

2.ChangethedefaultWelder’sGapfrom

1/8”to3/32”:

   2   * GAP 0-3/32 INCH

3.EnterOffset:

2 4   OFST 24 INCH

4.Entertheadvance:

 2   (Advance) RUN 32 INCH

5.EntertheRollandcalculatethepipe

lengthandunknownbendangle:

1  

  (Roll) LNTH 42-1/16 INCH

 CUT 35-1/4 INCH

 TO 3-5/16 INCH

 GAP 0-3/32 INCH

 FIT° 40.46°

 IARC 4-1/32 INCH

 CARC 6-11/32 INCH

 OARC 8-11/16 INCH

*Settingwelder'sgapto3/32inchwill

temporarilysettheoutputsto1/32fractional

resolution.Tokeepoutputsintheircurrent

1.EnterOffset:

1 7   OFST 17 INCH

2.Entertheadvance:

2    (Advance) RUN 28 INCH

3.EntertheRollandcalculatethepipe

lengthandunknownbendangle:

6  1  2

  (Roll) LNTH 33-3/8 INCH

 FIT° 33.02°

Continuepressingthe keytoviewall

relatedvalues.

Rolling Offset – Cut Length

Find the end-to-end pipe length for a rolling

pipe offset with a 13” Roll, a 24” Offset,

and an advance of 32”. The bend angle is

unknown. This example assumes 6” Steel,

factory made long radius butt weld elbows

are used with a Welder’s Gap of 3/32” (the

default is 1/8”).

Note: AllTake-Outcalculationsarebased

onCarbonSteelO.D.SeetheCut Length

– Known Take-Out Valueexampletosolve

CutLengthsforknownTake-Outvalues.

KEYSTROKE DISPLAY

  ALL CLEArEd

(cont'd)

(cont'd)

KEYSTROKE DISPLAY

KEYSTROKE DISPLAY

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments