Calculated-industries 4095-B Pocket Reference Guide User Manual download pdf (Page 16)

 MATH CHAIn

 (Repeats options) MATH OrdEr

ENTERING DIMENSIONS

Linear Dimensions

When entering feet-inch values, enter dimen-

sions from largest to smallest — feet before

inches, inches before fractions. Enter fractions

by entering the numerator (top number),

pressing  (Fraction Bar key) and then the

denominator (bottom number).

Note: If a denominator is not entered, the

fractional setting value is used.

Examples of how linear dimensions are

entered (press  after each entry):

DIMENSIONS KEYSTROKES

5 feet  

5 feet, 1 ½ inches       

17.5 meters     

1250 millimeters      

Square and Cubic Dimensions

Examples of how square and cubic dimensions

are entered (press 

after each entry):

DIMENSIONS KEYSTROKES

14 square inches    

11 square feet    

POCKET REFERENCE GUIDE — 17

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 37 38

No comments

Calculated-industries 4095-B Pocket Reference Guide User Manual Page 16